Investigation number
199301404
Occurrence date
State
New South Wales
Report release date
Report status
Final
Investigation type
Occurrence Investigation
Investigation status
Completed
Aviation occurrence category
Fuel contamination
Occurrence class
Accident

The helicopter departed Waste Point helipad at about 0925 to resupply huts with rations and fuel, and to undertake feral animal control. Apart from the cargo, a second crewmember and a passenger were carried. The aircraft approached the first hut (Tin Hut) in clear sky conditions with nil wind. The pilot said he carried out an aerial inspection of the landing area before commencing a landing towards the north. As the aircraft turned onto final approach at an altitude of about 6000 feet, with speed reducing to 20 knots, the engine lost power and the main rotor RPM drooped below the green arc. With about 100 metres left to run to the landing area, and unable to increase engine power, the pilot attempted an autorotation approach. The helicopter landed heavily and bounced before the tail rotor struck the ground. At the time of the accident the aircraft was being flown at about maximum gross weight. Manufacturer information indicated that the aircraft should have been capable of hovering in ground effect with regard to the ambient altitude/temperature conditions. The engine was subsequently removed from the aircraft and bench tested. No operational problems were revealed. The fuel control unit was then removed from the engine and tested. The test revealed that the fuel control unit had a slower than acceptable acceleration response time. This was due to contamination of the fuel control unit with what appeared to be sand. It is considered likely that in a marginal situation of high gross weight and altitude, any delay in fuel control response for increased engine power may have resulted in a considerable loss of height whilst the fuel control unit was responding to demand. The reason why the fuel control unit was contaminated could not be positively determined. The fuel control filter was serviceable and should have prevented the passage of grit into the fuel control unit. However, prior to engine start with the aircraft boost pump operating, fuel from the aircraft fuel supply can bypass the fuel pump and filter. Such contamination of the fuel supply need only have happened once, leaving the fuel control unit contaminated in such a way as to only become apparent at some later stage when engine response was critical.

Aircraft Details
Manufacturer
Aerospatiale Industries
Model
AS.350D
Registration
VH-PTH
Sector
Helicopter
Departure point
Waste Point, 7km N Jindabyne
Destination
Tin Hut, 27km NW Jindabyne
Damage
Substantial