Previous updates


Update 18 December 2012

The occurrence

On 29 October 2012, a Cessna 172N, registered VH-TKI, was being operated on a flight from Coldstream, Victoria to a private airstrip at Bagshot, Victoria, with a pilot and two passengers on board. The private flight was being conducted to position the aircraft for maintenance.

The aircraft arrived at the airstrip at about 1300 Eastern daylight-saving time. A witness, who was located at the southern end of the airfield, observed a Tecnam aircraft land from the south as the Cessna 172 entered the circuit. The Tecnam landed and backtracked to a maintenance facility located on the southern end of the airstrip.

The pilot of the Cessna overflew the strip then conducted a right circuit to land. The passenger seated behind the pilot stated that all the occupants were focussing their attention on the Tecnam on the airstrip during the circuit and final approach.

The witness at the airfield stated that, as the Tecnam cleared the airstrip, the Cessna was on a short final approach. He saw the aircraft contact a powerline, located at the southern end of the airfield. The aircraft rotated over the powerline, significantly reducing its forward speed and causing it to impact the runway in an almost inverted attitude.

The aircraft came to rest inverted, and a post-impact, fuel-fed fire initiated at the wing roots and destroyed the aircraft (Figure 1). Witnesses reached the aircraft quickly and assisted the occupants. However, the front seat passenger was fatally injured, the pilot was seriously injured and the rear seat passenger sustained minor injuries.

Figure 1: Accident site of the Cessna 172, VH-TKI

Accident site of the Cessna 172, VH-TKI

Source: ATSB

Examination of the aircraft showed that its nose landing gear contacted the powerline. The powerline was located 7 m above ground level and about 140 m from the end of the 900 m long landing strip (Figure 2).

The powerline had no markers fitted, nor were any required under the current Australian Standards for private landing strips. The owner of the landing strip advised that he routinely provided advice to pilots using the airstrip of the location of the powerline and of the need to land a significant distance down the airstrip to avoid the wire if landing from the south.

Figure 2: High level view of runway

Accident site of the Cessna 172, VH-TKI

Source: Google

Investigation activities

The on-site phase of the investigation concluded on 2 November 2012. The investigation is continuing and will include analysis of the circumstances surrounding the wirestrike including, but not limited to:

  • the location of the powerline in relation to the airstrip
  • requirements for powerline markers
  • pilots’ knowledge of the powerline’s location
  • pilot distraction
  • pilot visibility
  • pilot experience
  • the circuit flown by the pilot.

The information contained in this web update is released in accordance with section 25 of the Transport Safety Investigation Act 2003 and is derived from initial investigation of the occurrence. Readers are cautioned that new evidence will become available as the investigation progresses that will enhance the ATSB’s understanding of the occurrence as outlined in the web update. As such, no analysis or findings are included in this update.



Update 2 November 2012

The ATSB team has now completed the on-site stage of the investigation. The team has:

  • examined the wreckage
  • interviewed one of the passengers and the aircraft owner
  • reviewed the aircraft’s maintenance logs.

The ATSB’s investigation will now continue off-site. 

This page will be updated as significant information comes to hand.

The ATSB aims to finalise its investigation within 12 months.

Subscribe now to receive news and information from the ATSB and follow us on Twitter @atsbinfo for investigation updates. 


Update 30 October 2012

The ATSB team is on-site:

  • coordinating activities with local police and Coronial staff
  • interviewing witnesses
  • conducting initial site assessment
  • planning site activities.


29 October 2012

The ATSB has sent a team of investigators to begin the on-site phase of the investigation. The team comprises experts in engineering and aircraft operations. It is expect they will arrive mid-morning (Tuesday 30 October) and spend three to five days at the accident site.
As part of the on-site investigation, the team will be:

  • examining the wreckage for evidence
  • interviewing witnesses and aircraft operator
  • reviewing maintenance documents.

 The ATSB will also review the pilot’s training and experience and collate and analyse witness information.
If you have any information about the accident please call the ATSB on 1800 020 616.