Aviation safety investigations & reports

Bell Helicopter Co 206B(III), VH-NVH

Investigation number:
Status: Completed
Investigation completed


The pilot of the Bell Jet Ranger reported that while cruising at about 2,500 ft AGL, the rotor RPM indication decreased to zero. He initiated auto-rotation immediately by lowering the collective pitch. The controls were very stiff, however all engine parameters were normal. The helicopter descended at higher than normal speed and landed heavily. The right skid crosstube support failed and the aircraft rolled onto its side. Both occupants vacated the wreckage with minor injuries.

The pilot reported that he did not hear the low rotor alarm and did not notice the low rotor RPM caution light illuminate.

Investigation determined that the drive spline and coupling to the hydraulic pump and rotor tachometer generator were devoid of lubrication and worn to the degree that drive to both units had failed. This resulted in the loss of hydraulic power to the controls and the loss of the main rotor speed indication.

The low rotor RPM sensor which provides a signal to activate the low rotor alarm and the low rotor RPM caution light was tested and functioned normally. However, it is likely that the pilot did not notice the low rotor RPM warnings, due to his immediate initiation of an auto-rotation, and the ambient light conditions. The warning horn is cancelled by a cut-out switch on the collective pitch handle when the handle is lowered as in the case of an auto-rotation. As the helicopter was tracking south at the time, the bright sun from the northeast would have made illumination of the low rotor RPM caution light difficult to distinguish.

Investigation of the maintenance requirements for the helicopter found that, prior to January 1998, the hydraulic pump drive splines were required to be lubricated by hand every 1200 hours or twelve months, whichever came first, or under extreme operating conditions, every 300 hours. In January 1998 the manufacturer issued a revised manual with a changed requirement for the Bell 206B III model to lubricate the hydraulic pump drive splines every 300 hours with no calendar requirement.

The accident helicopter had only accumulated about 90 hours time in service since January 1998 and 217 hours since the initial issue of its Australian certificate of airworthiness in 1990.

Safety Action

Because of the deficiency with the manufacturers maintenance requirements, identified during the investigation, the following safety recommendations have been issued.


The Australian Transport safety Bureau recommends that Bell Helicopter Textron P/L revise the maintenance manual for the Bell 206B III series helicopter to require the inspection and lubrication of the hydraulic pump drive splines on a calendar basis, in addition to the hourly time in service inspection and lubrication requirements.


The Australian Transport Safety Bureau recommends that the Civil Aviation Safety Authority advise Australian operators of Bell 206B III series helicopters of the finding of this accident and revise the calendar requirement for the lubrication of the hydraulic pump splines.


The Australian Transport Safety Bureau recommends that the Federal Aviation Administration note the findings of this accident. It also recommends that the Federal Aviation administration alert all operators of bell 206B III series helicopters of the deficiency in the maintenance manual.

General details
Date: 12 July 2000   Investigation status: Completed  
Time: 1520 hours EST    
Location   (show map): 11 km S Aberdeen    
State: New South Wales   Occurrence type: Forced/precautionary landing  
Release date: 13 June 2001   Occurrence category: Accident  
Report status: Final   Highest injury level: Minor  

Aircraft details

Aircraft details
Aircraft manufacturer Bell Helicopter Co  
Aircraft model 206  
Aircraft registration VH-NVH  
Serial number 1163  
Type of operation Private  
Sector Helicopter  
Damage to aircraft Destroyed  
Departure point Tamworth NSW  
Destination Bankstown NSW  
Crew details
Role Class of licence Hours on type Hours total
Pilot-in-Command Private 229.0 2178
  Crew Passenger Ground Total
Minor: 1 1 0 2
Total: 1 1 0 2
Last update 13 May 2014